2026-10-18 14:07 UTC
I would appreciate input and help for using a debugger for #Rust development:
I usually don't use or need a debugger, but I would like to step through some code to get a better understanding. I would prefer to do this from within my #NeoVim so I installed https://codeberg.org/mfussenegger/nvim-dap and the default lldb command line tools.
When trying to start a pre-build binary via my config, I get "Error on launch: executable module does not exist" even when hard-coding the correct path in my config [...]
Replies (1)
-
@achim@social.saarland 2026-10-18 14:10
[...] I found hints that some of the involved tools have special #Rust forks that I might have to install, but I have trouble finding reliably information. There is a lot of information, but often very IDE specific, out dated, ... Would somebody be willing to share a minimal - ideally NeoVim based - setup to start a debugger to step through #Rust code?